According to the supported hardware page QNX supports the PPC 7400 - does
this include altivec support?
If not, will that come?
Also, if there is altivec support - are there any documentation about it?
According to the supported hardware page QNX supports the PPC 7400 - does
this include altivec support?
If not, will that come?
Also, if there is altivec support - are there any documentation about it?
“Jonas Ørting” <jno@mailme.dk> wrote in message
news:9p1m3q$8g$1@inn.qnx.com…
According to the supported hardware page QNX supports the PPC 7400 - does
this include altivec support?
If not, will that come?Also, if there is altivec support - are there any documentation about it?
The kernel supports restoring/saving the Altivec registers, but the GNU tool
chain does not support it. There are patches on Altivec’s site - but don’t
think that the patches will go in anytime soon (for stability reasons).
-Adam