I have got my Elo Accutouch serial touchscreen up and running. My only
problem is with the calibration of the touchscreen, as you move from the
bottom left towards the upper right the cursor moves ahead of the touch at
an exponential rate. I have downloaded and used the calib_114 calibration
program but it gives me the same results as acalib. Any ideas on how to
remedy this would be greatly appreciated. Thanks.
Ross Brantner
I found the solution, it was posted on the QDN. Had to use stty -nl
</dev/ser2 (2 is serial port with touchscreen attached). Thanks to everyone
that helped me out trying to et this touchscreen up and running.
Ross Brantner
“Ross Brantner” <brantner@nrc.net> wrote in message
news:9mdiii$ffn$1@inn.qnx.com…
I have got my Elo Accutouch serial touchscreen up and running. My only
problem is with the calibration of the touchscreen, as you move from the
bottom left towards the upper right the cursor moves ahead of the touch at
an exponential rate. I have downloaded and used the calib_114 calibration
program but it gives me the same results as acalib. Any ideas on how to
remedy this would be greatly appreciated. Thanks.Ross Brantner