Per QNX site, I set up the card definition using the orinoco driver however
I do not know where to set the specific ESSID of my network. Without this
the card is not fully recognized. I do, however, see the card when using
pin so the system is finding it.
Any help would be appreciated.
Hi Jared,
Did you get this card to work in the end? It’s my understanding that the
Linksys card is not an orinoco type card so the driver probably won’t work.
If it does work, then try
use devn-orinoco
to get the command line options. One of the should be to set the SSID
Regards
Dave Edwards
Abicom
jared feider wrote:
Per QNX site, I set up the card definition using the orinoco driver however
I do not know where to set the specific ESSID of my network. Without this
the card is not fully recognized. I do, however, see the card when using
pin so the system is finding it.
Any help would be appreciated.