Guys,
I’m using QNX 6.1.0A on Daytona Board(XScale).
There is ‘devg-cotulla.so’ for graphics drivers.
Our daytona has 640 X 350 LCD screen.
And ‘cotulla.conf’ describe our screen properties like below.
I want to know how I can change screen to other resolution mode. (ex more
smaller resolution.)
Can I do it though changing contulla.conf ?
If so, is there anyone who teach me how I can ?
If not, Should I change ‘devg-cotulla’ driver ?
‘devg-cotulla.so’ is included in Xcale BSP on prebuilt binary.
Where I get the source code of ‘devg-cotulla.so’ ?
Any idea ?
YongSung
File ‘cotulla.conf’.
devg-cotulla.so parameters for tailoring to specific boards and display
modes.
hsw Horizontal Sync Width
elw End-of-line pixel clock wait
blw Beginning-of-line pixel clock wait
vsw Vertical sync pulse width
efw End-of-frame line clock wait count
bfw Beginning-of-frame line clock wait count
vsp Vertical Sync Polarity (0 = active high, 1 = active low)
hsp Horizontal Sync Polarity (0 = active high, 1 = active low)
pcp Pixel Clock Polarity (0 = data sampled on rising edge of L_PCLK, 1
=data sampled on falling edge)
oep Output enable polarity (0 - L_BIAS pin is active high in display mode
and parallel data input mode)
acb AC bias pin frequency
pcd Pixel Clock Divisor
type 1 = Active Display 0 = Passive Display
num 0 = Single Panel 1 = Dual Panel
board 0 = Daytona 1 = Lubbock
x width of panel
y height of panel
The driver will use the first un-commented entry.
\
Lubbock board, dual panel, passive display
#hsw=30,elw=7,blw=107,vsw=1,efw=0,bfw=0,vsp=0,hsp=0,pcp=1,oep=0,acb=0,pcd=9,
type=0,num=1,board=1,x=640,y=480
Daytona board, single panel, active display
hsw=30,elw=15,blw=73,vsw=1,efw=1,bfw=98,vsp=0,hsp=0,pcp=1,oep=0,acb=0,pcd=2,
type=1,num=0,board=0,x=640,y=350