I’m trying to set up the dialer to use a standard (non-Win) modem. It does
know to try /dev/ser3, but with the terminal turned on, it appears not to be
listening (or replying).
Is there some other configuration that needs to happen? If so, where is it
documented?
If not, I noticed that the Class is listed as “Communication (Unknown)” - is
there some other problem?
The relevant output of pci -v yields:
Class = Communication (Unknown)
Vendor ID = 14f1h, Conexant Systems, Inc.
Device ID = 1059h, HCF 56k Data/Fax/Voice Modem (Worldwide)
PCI index = 0h
Class Codes = 078000h
Revision ID = 8h
Bus number = 0
Device number = 12
Function num = 0
Status Reg = 290h
Command Reg = 4h
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = 20h
Cache Line Size= 0h
PCI IO Address = 0h length 8 disabled
Subsystem Vendor ID = 148dh
Subsystem ID = 1059h
Max Lat = 0ns
Min Gnt = 0ns
PCI Int Pin = INT A
Interrupt line = no connection
Capabilities Pointer = 40h
Capability ID = 1h
Capabilities = 4822h - 0h