6.2 with i845

hello!

I try to run 6.2 PE on my pc based on i845 chipset (with integrated audio,
graphics and ethernet). QNX does not detect any of these devices and Photon
runs in pure svga mode. What should I do to convince QNX to make use of the
audio, net and video?

regards
WP

“Wojciech Piechowski” <wojciech.piechowski@radmor.com.pl> wrote in message
news:b47mtk$9ip$1@inn.qnx.com

hello!

I try to run 6.2 PE on my pc based on i845 chipset (with integrated audio,
graphics and ethernet). QNX does not detect any of these devices and
Photon
runs in pure svga mode. What should I do to convince QNX to make use of
the
audio, net and video?

Pay them to support it I guess

regards
WP

PE is not the free version. So he did pay to support QNX. You post wasn’t
very helpful or kind.



“Mario Charest” postmaster@127.0.0.1 wrote in message
news:b482j7$m01$1@inn.qnx.com

“Wojciech Piechowski” <> wojciech.piechowski@radmor.com.pl> > wrote in message
news:b47mtk$9ip$> 1@inn.qnx.com> …
hello!

I try to run 6.2 PE on my pc based on i845 chipset (with integrated
audio,
graphics and ethernet). QNX does not detect any of these devices and
Photon
runs in pure svga mode. What should I do to convince QNX to make use of
the
audio, net and video?

Pay them to support it I guess


regards
WP

The network should work if you specify the vendor ID and device ID when you
start up io-net.

Try the following:

slay -f io-net
io-net -dspeedo vid=0x8086,did=0x1039 -ptcpip


Jens


“Wojciech Piechowski” <wojciech.piechowski@radmor.com.pl> wrote in message
news:b47mtk$9ip$1@inn.qnx.com

hello!

I try to run 6.2 PE on my pc based on i845 chipset (with integrated audio,
graphics and ethernet). QNX does not detect any of these devices and
Photon
runs in pure svga mode. What should I do to convince QNX to make use of
the
audio, net and video?

regards
WP