Hi,
I am trying to use a rs485 com port on my computer running qnx neutrino and
it is not working as i expected.
The computer i am using is a nova8890:
http://www.jenlogix.co.nz/products/nova-8890.htm
Is devc-ser8250 the correct driver to use for 485 as well? Are there any
particular arguments I should give it to run 485?
Khian Hao
Khian Hao Lim <khianhao@stanford.edu> wrote:
KHL > Hi,
KHL > I am trying to use a rs485 com port on my computer running qnx neutrino and
KHL > it is not working as i expected.
KHL > The computer i am using is a nova8890:
KHL > http://www.jenlogix.co.nz/products/nova-8890.htm
KHL > Is devc-ser8250 the correct driver to use for 485 as well? Are there any
KHL > particular arguments I should give it to run 485?
KHL > Khian Hao
The devc-8250 driver works just fine with RS-485 as long as your going
point to point OR your the master side of point to multi-point. If
your the slave side of point to multi-point, then I believe that you’ll
need to add some smarts to your serial driver.
–
Bill Caroselli – Q-TPS Consulting
1-(708) 308-4956 <== Note: New Number
qtps@earthlink.net