Hi, everyone
I’m a newer to QNX. When I built a project under IDE 6.2.1 the system seems
can not find a lib file: …/arm/a-le-g/libmax533_dtoa.a. But I found the
file is in a different directory: …/arm/a-le/libmax533_dtoa.a. Should I set
some environment paras somewhere? Seems a bit silly :-; . Here are the build
messages:
make CPULIST=x86/arm all
make -j 1 -Carm -fMakefile all && make -j 1 -Cx86 -fMakefile all
make[1]: Entering directory /home/mjkadour/workspace/max533_dtoa/arm' make -j 1 -Co-le -fMakefile all && make -j 1 -Co-le-g -fMakefile all make[2]: Entering directory /home/mjkadour/workspace/max533_dtoa/arm/o-le’
make[2]: Nothing to be done for all'. make[2]: Leaving directory /home/mjkadour/workspace/max533_dtoa/arm/o-le’
make[2]: Entering directory
`/home/mjkadour/workspace/max533_dtoa/arm/o-le-g’
/bin/rm -f /home/mjkadour/workspace/max533_dtoa/arm/o-le-g/max533_dtoa_g
/usr/bin/qcc -Vgcc_ntoarm -Wl,–no-keep-memory -o/home/mjkadour/workspac
e/max533_dtoa/arm/o-le-g/max533_dtoa_g
ax533_dtoa.o -L. -L/armle/lib -L/armle/usr/lib -Bstatic -l/home/mjkad
our/workspace/max533_dtoa/…/max533_dtoa_lib/arm/a-le-g/libmax533_dtoa.a
-l/home/mjkadour/workspace/max533_dtoa/…/sa1110_gpio_lib/arm/a-le-g/libsa11
10_gpio.a -Bdynamic -EL -g
/usr/bin/ntoarm-ld: cannot open
/home/mjkadour/workspace/max533_dtoa/…/max533_dtoa_lib/arm/a-le-g/libmax533
_dtoa.a: No such file or directory
cc: /usr/bin/ntoarm-ld error 1
make[2]: *** [/home/mjkadour/workspace/max533_dtoa/arm/o-le-g/max533_dtoa_g]
Error 1
make[1]: *** [all] Error 2
make: *** [all] Error 2
make[2]: Leaving directory /home/mjkadour/workspace/max533_dtoa/arm/o-le-g' make[1]: Leaving directory /home/mjkadour/workspace/max533_dtoa/arm
Thanks in advance!
Jack Li
Electronic Engineer
905-673-8501 Ext.245
Cardiogenics Inc.
6295 Northam Drive, Unit 8
Mississauga, Ontario, Canada
L4V 1H8