QNX 6.3.1 Enet Config Problem

QNX Newsgroups (Archives) qnx.newuser
1

Hi,

  1. I’m wondering if there is a known problem with QNX 6.3.1 NC that prevents
    it from automatically recognizing my Realtek Ethernet controller. “en0” is
    not listed when I execute “ifconfig -a”. I’ve installed QNX 6.2 on this SBC
    and the installation asked me whether I wanted to install networking. QNX
    6.2 recognized my Ethernet card and I was able to set the IP address using
    the network utility in Photon. I was given no option in the 6.3.1
    installation regarding the network. Interestingly, I can run the “pci”
    utility and see the device. I’d appreciate any insights,
  2. I’m trying to startup the network manually. I executed:
    slay -f io-net
    io-net -d rtl did=0x8139,vid=0x10EC, verbose,-p tcpip
    I get the response:
    Vendor…0x10EC
    Device…0x8139
    Revision…0x0
    I/O port base…0xE800
    Interrupt…0xb
    MAC Address 000000 000000
    I execute “netmanager”, but I still don’t see “en0” listed in response to
    ifconfig -a
    I will be greatful for any one who can help me out. Thanks in advance,

Eric

2

Eric wrote:

Hi,

  1. I’m wondering if there is a known problem with QNX 6.3.1 NC that prevents
    it from automatically recognizing my Realtek Ethernet controller. “en0” is
    not listed when I execute “ifconfig -a”. I’ve installed QNX 6.2 on this SBC
    and the installation asked me whether I wanted to install networking. QNX
    6.2 recognized my Ethernet card and I was able to set the IP address using

QNX 6.2.1 has such an issue if you’ve not finished the installation.


PS: There is no QNX 6.3.1, yet.

3

Thanks for your help. I feel so stoopid!

Eric

“Evan Hillas” <blarg@blarg.blarg> wrote in message
news:ckdgg5$1e0$1@inn.qnx.com…

Eric wrote:
Hi,

  1. I’m wondering if there is a known problem with QNX 6.3.1 NC that
    prevents
    it from automatically recognizing my Realtek Ethernet controller. “en0”
    is
    not listed when I execute “ifconfig -a”. I’ve installed QNX 6.2 on this
    SBC
    and the installation asked me whether I wanted to install networking.
    QNX
    6.2 recognized my Ethernet card and I was able to set the IP address
    using


    QNX 6.2.1 has such an issue if you’ve not finished the installation.


    PS: There is no QNX 6.3.1, yet.