Is there any internal modem ( PCI board ) supported on QNX6?
Probably the board would have to emulate serial line to work with QNX.
Jiøí Kristek
As long as it is a hardware modem it should work using the devc-ser8250
driver to interface with the UART on the modem.
Note: Software modems are not supported.
-Joe
“Jiøí Kristek” <jkristek@retia.cz> wrote in message
news:d01b4l$51g$1@inn.qnx.com…
Is there any internal modem ( PCI board ) supported on QNX6?
Probably the board would have to emulate serial line to work with QNX.Jiøí Kristek
A quick follow-up to my last post…you will need to pass the ioport and
irq of the modem to the serial driver. You can do a ‘pci -vvv’ to get this
information from the pci sever.
Regards,
Joe
“Joe Mammone” <hw@qnx.com> wrote in message news:d01tfn$htj$1@inn.qnx.com…
As long as it is a hardware modem it should work using the devc-ser8250
driver to interface with the UART on the modem.Note: Software modems are not supported.
-Joe
“Jiøí Kristek” <> jkristek@retia.cz> > wrote in message
news:d01b4l$51g$> 1@inn.qnx.com> …
Is there any internal modem ( PCI board ) supported on QNX6?
Probably the board would have to emulate serial line to work with QNX.Jiøí Kristek
\