Phindows via serial port

QNX Newsgroups (Archives) qnx.gui
1

Hello

have somebody connected Phwindows 2.0 to QNX 6 via serial port /direct cabel
or via modems/? If yes can you pass me what we have to set up on QNX site?
Installation guide step by step will be very welcome.


Thank

2

On your QNX 6.2.1 machine set the serial port to use 115200 baud rate and
put to edit mode (stty </dev/ser1 +edit baud=11520)

Then edit your /etc/config/ttys file to look as follows:

con1 “/bin/login” qansi-m on
con2 “/bin/login” qansi-m on
con3 “/bin/login” qansi-m on
con4 “/bin/login” qansi-m on
ser1 “/bin/login” qansi-m on

Start Phindows, after you see “Phindows” in green text hit a key. You will
get a login at a command prompt in the Phindows window. Login, then issue
the following command: “stty < /dev/ser1 +raw ;phrelay”

You will then get the Photon login screen.

Regards,

Joe
“Karol Hecko” <karol@becom.sk> wrote in message
news:c1ioih$j6t$1@inn.qnx.com…

Hello

have somebody connected Phwindows 2.0 to QNX 6 via serial port /direct
cabel
or via modems/? If yes can you pass me what we have to set up on QNX site?
Installation guide step by step will be very welcome.


Thank

3

Is there an option to set so that if the connection is broken, I can
re-login?