Hello,
have anyone tried to run QNX 6.1 on the DIL/NetPC ( www.dilnetpc.com) ?
The CPU “AMD SC410” is supported by QNX 6.1.
Thank you very much for your help !
Best regards
Fiffi
Hello,
have anyone tried to run QNX 6.1 on the DIL/NetPC ( www.dilnetpc.com) ?
The CPU “AMD SC410” is supported by QNX 6.1.
Thank you very much for your help !
Best regards
Fiffi
With the sc400 you can attempt to use the build file in /x86/boot/build/sc400.build.
Hello cdm,
Can i use the Dil/NetPC as target with the NC version of QNX 6.1, without BSP’s ?
Best regards
Fiffi
Depends - does the unit have a BIOS?
Hello cdm,
Depends - does the unit have a BIOS?
I am not sure, at her website stands:
The DIL/NetPCs DNP/1486 and ADNP/1486 don’t offer a BIOS setup feature. There are different BIOS image files for downloading to the Flash memory chip of these DIL/NetPCs. Each BIOS image file offers special features.
Normally the board runs with “Linux Kernel Version 2.4” or “ROM-DOS Version 6.22”.
Best regards
Fiffi
Looks like you will need to build a custom image, etc, etc to run on these devices. It’s not too hard really.