parallel port problem

QNX Newsgroups (Archives) qnx.qnx4
1

tanks at all…
…I have other little problem…now…
I can read on log the base addres IO of my Parallel card…
In according Dev.par -p 278 -N /dev/par2 in sysinit.node haven’t
result.
When I reboot, this line, stop bootup.
The base addres can I read on show_pci is followed:

Base Address = IO@9000h length 8 bytes IO@9400h length 8 bytes
IO@9800h length 8 bytes IO@9c00h length 8 bytes IO@a000h length 8
bytes IO@a400h length 16 bytes

how can i configure my parallel port for print?

regards.

2

“cisanet” <cisanet@libero-dot-it.no-spam.invalid> wrote in message
news:d7lakb$t2i$2@inn.qnx.com…

tanks at all…
.I have other little problem…now…
I can read on log the base addres IO of my Parallel card…
In according Dev.par -p 278 -N /dev/par2 in sysinit.node haven’t
result.
When I reboot, this line, stop bootup.
The base addres can I read on show_pci is followed:

Do you have a & at the end of the line.

Base Address = IO@9000h length 8 bytes IO@9400h length 8 bytes
IO@9800h length 8 bytes IO@9c00h length 8 bytes IO@a000h length 8
bytes IO@a400h length 16 bytes

how can i configure my parallel port for print?

regards.

3

YES…
I forgot to wrte…before.
I’m still on bed point–didn’t work, was tested on varius pc ed whit 2
type of card but whit same chip…8205.

regards