Hello everyone
I’m very new to all this, so if the following sounds like a stupid
question, it probably is. I have looked through the help
documentation and other newgroups, but didn’t find an answer.
I was successfully debugging a program before installing SP2 on QNX
momentics 6.3. Now when I launch the debugger, I get the message:
error: unableto parser binary information from file
I believe that I have made all the changes that are suggested in the
help file when going to SP2.
Any help will be greatly appreciated
Lee Russell
Lee Russell <me@leerussell.co.uk> wrote:
Hello everyone
I’m very new to all this, so if the following sounds like a stupid
question, it probably is. I have looked through the help
documentation and other newgroups, but didn’t find an answer.
I was successfully debugging a program before installing SP2 on QNX
momentics 6.3. Now when I launch the debugger, I get the message:
error: unableto parser binary information from file
Hm… did you rebuild the executable?
-David
I believe that I have made all the changes that are suggested in the
help file when going to SP2.
Any help will be greatly appreciated
Lee Russell
–
David Gibbs
QNX Training Services
dagibbs@qnx.com
On 20 Oct 2005 16:37:02 GMT, David Gibbs <dagibbs@qnx.com> wrote:
Lee Russell <> me@leerussell.co.uk> > wrote:
Hello everyone
I’m very new to all this, so if the following sounds like a stupid
question, it probably is. I have looked through the help
documentation and other newgroups, but didn’t find an answer.
I was successfully debugging a program before installing SP2 on QNX
momentics 6.3. Now when I launch the debugger, I get the message:
error: unableto parser binary information from file
Hm… did you rebuild the executable?
I had rebuilt the executable, but I decided to delete everything and
start again. This time it appears to have worked. Thanks for the
help
-David
I believe that I have made all the changes that are suggested in the
help file when going to SP2.
Any help will be greatly appreciated
Lee Russell