I’m trying to start a machine where ther server running QNX 4.24. My network
card is model winbond 89C940, configuration ok, but when to try enter in the
network ( QNX 1000/2000 Boot Rom Version 1.00C), recognizes the card phys
address netmap, booting starting from node A(number server address) and a
message of error- RX error - Missed Packets. Somebody can help me, please.
thanks!
“Bryan” <brysantneves@hotmail.com> wrote in message
news:endav8$crc$1@inn.qnx.com…
I’m trying to start a machine where ther server running QNX 4.24. My
network
card is model winbond 89C940, configuration ok, but when to try enter in
the
network ( QNX 1000/2000 Boot Rom Version 1.00C), recognizes the card phys
address netmap, booting starting from node A(number server address) and a
message of error- RX error - Missed Packets. Somebody can help me, please.
Check argument of netboot from server, there are option to slow down the
rate of transfer.
The problem is that the BOOT code is located in the ROM. Thus the CPU
fetches the instruction from the ROM over the ISA bus slowing the CPU to the
point where it can’t handle the incoming data fast enough. Another option
is to enable the BIOS caching at the address where the BOOT ROM sits.
thanks!
I usually find that if I can get the network card on both the client and
server to full duplex, all works well.
“Bryan” <brysantneves@hotmail.com> wrote in message
news:endav8$crc$1@inn.qnx.com…
I’m trying to start a machine where ther server running QNX 4.24. My
network
card is model winbond 89C940, configuration ok, but when to try enter in
the
network ( QNX 1000/2000 Boot Rom Version 1.00C), recognizes the card phys
address netmap, booting starting from node A(number server address) and a
message of error- RX error - Missed Packets. Somebody can help me, please.thanks!