Hi All
Running QNX 6.1.0
I have a system based on the AMD LX800 processor card.
It has a usb controller, pci reports :
Class = Serial Bus (Universal Serial Bus)
Vendor ID = 1022h, Advanced Micro Devices
Device ID = 2094h, Unknown Unknown
PCI index = 0h
Class Codes = 0c0310h
Revision ID = 2h
Bus number = 0
Device number = 15
Function num = 4
Status Reg = 230h
Command Reg = 6h
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = 0h
Cache Line Size= 8h un-cacheable
PCI Mem Address = effff000h 32bit length 4096 enabled
Subsystem Vendor ID = 1022h
Subsystem ID = 2094h
Max Lat = 0ns
Min Gnt = 0ns
PCI Int Pin = INT D
Interrupt line = 11
Capabilities Pointer = 40h
Capability ID = 1h
Capabilities = c802h - 0h
But I get the response:
No USB Controller found
Error initialising the stack
Thing is, this did work at one point…
Thought is was a hardware failure when it stopped working…
Got new hardware, still not working???
I am sure it did work, perhaps I was dreaming!!!
But seriously, any one know if the driver is likely to work with this chipset, I know the software version is getting on a bit, but I have a load of legacy systems to keep running.
Thanks
Bren